We suspect that some Batch 4 Aero Pro units did not receive the proper ESC setup procedure during assembly. To avoid improper operation, all Batch 4 owners must complete the following before first use.
Motor Detection
- Place the board on a stable surface with the wheels off the ground.
- Make sure the board is completely off (not in standby).
- Turn the board on using the power button.
- Press the power button 3 times quickly. This will start automatic motor detection.
- Wait until detection is complete (about 40 seconds).
- Turn the board off with the board’s power button, then turn it on again.
Advanced Parameters
With the board and remote on, press the Mode Button 8 times quickly to open Advanced Parameters. Adjust the settings as follows.
2. MOTOR RUN MODE: HYBRID
5. BATT CELLS: 14S
9. MOTOR RUN DIR: Change if board moves in wrong direction.
10. L MODE REF: 40
11. L MODE CUR: 15
12. L SPEEDUP LINE: 10
13. L BRAKE LINE: 40
14. E MODE REF: 60
15. E MODE CUR: 40
16. E SPEEDUP LINE: 10
17. E BRAKE LINE: 50
18. S MODE REF: 100
19. S MODE CUR: 60
20. S SPEEDUP LINE: 10
21. S BRAKE LINE: 60
22. S+ MODE REF: 100
23. S+ MODE CUR: 100
24. S+ SPEEDUP LINE: 10
25. S+ BRAKE LINE: 60
Support
If you need assistance with any of this, contact us.